RHOBA LAVIA L303
Old productname: RHOBAPLAST FORMould cleaner for cleaning of injection moulds and spinnerets. Removes thoroughly plastic deposits, acrylates, and resins.
Products
- RHOBA ALTIA – AVIATION
- RHOBA LAVIA – CLEANERS
- RHOBA PURIA – WATER TREATMENT
- RHOBA SUPRA – SURFACES
-
RHOBA UTILA - SERVICE/ACCESSORIES
- Hygiene and occupational safety
- Skin Care
- Dosing and measuring technology
- Accessories
-
Fluid Management-Service
-
Fluid Management
- Properties
- Application
- Technical data
- Note
- low volatility
- has proven itself when cleaning injection moulds and spinnerets
- does not attack material surfaces such as steel, aluminium, and non-ferrous metals
- thoroughly removes plastic deposits, acrylates, PA, PVC, PC, PPS, PEEK, resins, rubber residues, adhesive residues, paints, asphalt and tar, among other things
RHOBA LAVIA L303 is a highly effective, ready-to-use special cleaner.
Simply spray onto the surface to be cleaned or immerse the part to be cleaned and leave to act for 15 seconds. Then remove the residues with a brush, paintbrush or cloth.
Recommendation: The cleaning time can be shortened by heating the surfaces to be cleaned up to 90°C.
Plastic residues that are difficult to remove, e.g. burnt-on residues, should be soaked overnight.
Corrosion-sensitive materials should be protected with our RHOBA SUPRA C products after cleaning.
| Appearance | colourless liquid |
| Density at 20 °C | approx. 1.0 g/ml |
| Flash point | > 90 °C |
Before use, check material compatibility on an inconspicuous spot.
Follow the manufacturer's cleaning and care instructions! No liability can be accepted for improper use and any resulting damage.